Single Phase Voltage Monitoring Relay
Protect electrical equipment and motors from over-voltage and under-oltage. Normal/emergency power supply switching.
SINGLE PHASE MONITORING RELAY
GEYA Single Phase Monitoring Relay is a device intended for effective voltage automatic control and such equipment as home appliances and other devices in home and offices protection.
It is designed for the protection of single phase load un-allowable voltage variations in the mains. They have a wide range of adjustments, including power on time delay for protection on refrigerating, compressor and air conditioning equipment.
GEYA Single Phase Voltage Monitoring Relay provides for automatic load energizing after voltage parameters recovery within predetermines time relay.
The relays are compact in size and weight. They can be utilized both as independent switching devices and as controls for other switching devices, like magnetic starters.
GEYA Single Phase Monitoring Relay performs the function of protection against voltage drops.
It is designed to de-energize an industrial appliance single phase in case of inadmissible voltage variations in the mains with subsequent automatic re-energizing after the circuit parameters recovery.
Loads are connected to the relay either directly via relay terminals or through a magnetic starter, depending on the wattage.
Technical parameters | FV8-01 | FV8-02 |
Function | Monitoring voltage |
Supply terminals | A1-A2 |
Rated supply voltage | DC12V,AC/DC24V-48V,AC/DC110V-240V,AC220V |
Rated supply frequency | 45Hz-65Hz,0 |
Hysteresis | 5%-20% | 3%fixed |
Supply indication | green LED |
Time delay | Adjustable 0.1s-10s,10% |
Measurement error | ≤1% |
Run up delay at power up | 0.5s time delay |
Konb setting accuracy | 10% of scale value |
Reset time | 1000ms |
Temperature coefficient | 0.05%/℃,at=20℃(0.05%℉,at=68℉) |
Output | 1×SPDT |
Current rating | 10A(AC1) |
Switching voltage | 250VAC/24VDC |
Min. breaking capacity DC | 500mW |
Output indication | red LED |
Mechanical life | 1×107 |
Electrical life(AC1) | 1×105 |
Operating temperature | -20℃ to+55℃(-4℉to131℉) |
Storage temperature | -35℃ to+75℃(-22℉to158℉) |
Mounting/DIN rail | Din rail EN/IEC 60715 |
Protection degree | IP40 for front panel/IP20 terminals |
Operating position | any |
Overvoltage category | III. |
Pollution degree | 2 |
Max.cable size(mm 2) | solid wire max.1×2.5or 2×1.5/with sleeve max.1×2.5(AWG 12) |
Tightening torque | 0.8Nm |
Dimensions | 90×18×64mm |
Weight | 59g |
Standards | EN 60255-1,IEC60947-5-1 |
Relevant Products